Home › General › SPECIFICATIONS › P314 HYBRID TRANSMISSION / TRANSAXLE

P314 HYBRID TRANSMISSION / TRANSAXLE > SERVICE DATA



Transaxle fluid pressure
Engine Speed: 900 rpm
9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more
Hybrid vehicle transaxle assembly type T oil seal
LH side
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
RH side
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Input shaft type T oil seal
1.0 to 1.8 mm (0.0394 to 0.0709 in.)

Lower shift lever assembly
Tester Connection
Condition
Specified Condition
5 (IG) - Body ground
Power switch on (IG)
11 to 14 V
Power switch off
Below 1 V
4 (STP) - Body ground
Brake pedal depressed
11 to 14 V
Brake pedal released
Below 1 V
1 (E) - Body ground
Always
Below 1 V
Tester Connection
Shift Lever Position
Specified Condition
4 (P) - 3 (E2)
P
10 kΩ or higher
Other than P
Below 1 V
Tester Connection
Condition
Specified Condition
1 (SLS+) - 2 (SLS-)
Always
112 Ω
Shift lever position sensor
Tester Connection
Shift Lever Position
Specified Condition
8 (+B) - 1 (D)
D
Below 1 Ω
Except D
10 kΩ or higher
8 (+B) - 2 (N)
N
Below 1 Ω
Except N
4.2 to 5.2 kΩ
8 (+B) - 3 (P)
P
Below 1 Ω
Except P
10 kΩ or higher
8 (+B) - 4 (R)
R
Below 1 Ω
Except R
10 kΩ or higher
8 (+B) - 5 (MJ)
ALL
Below 1 Ω
8 (+B) - 6 (FD)
D or B
Below 1 Ω
Except D and B
10 kΩ or higher
8 (+B) - 7 (B)
B
Below 1 Ω
Except B
10 kΩ or higher
8 (+B) - 9 (RV)
R
Below 1 Ω
Except R
10 kΩ or higher