Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > ECO Switch Circuit

for Preparation Click here


DESCRIPTION

When the ECO mode switch (eco switch assembly) is turned on, the air conditioning amplifier assembly receives an ECO mode switch (eco switch assembly) ON signal and controls the air conditioning to enhance fuel efficiency.

WIRING DIAGRAM


E202856E02


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Air Conditioner / Data Test.

  1. Check the values by referring to the table below.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Control Range
    Diagnostic Note
    ECO Switch
    ECO mode switch (eco switch assembly) /
    OFF or ON
    ECO mode switch (eco switch assembly) not operated: OFF
    (when switch is not pressed)
    -
    ECO mode switch (eco switch assembly) operated: ON
    (when switch is pressed)

    OK:
    ECO mode switch (eco switch assembly) condition displayed on the intelligent tester changes with the actual switch operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT ECO MODE SWITCH (ECO SWITCH ASSEMBLY)
  1. Remove the ECO mode switch (eco switch assembly) (Click here).



    E230461E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I49-9 (ECU) - I49-6 (E)
    ECO mode switch (eco switch assembly) off
    (when switch is not pressed)
    10 kΩ or higher
    I49-9 (ECU) - I49-6 (E)
    ECO mode switch (eco switch assembly) on
    (when switch is pressed)
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (ECO Mode Switch (Eco Switch Assembly))



NG
REPLACE ECO MODE SWITCH (ECO SWITCH ASSEMBLY) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ECO MODE SWITCH (ECO SWITCH ASSEMBLY) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the I77 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I77-4 (ECOS) - I49-9 (ECU)
    Always
    Below 1 Ω
    I77-4 (ECOS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ECO MODE SWITCH (ECO SWITCH ASSEMBLY) - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I77-6 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)