Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



INSPECT INTERIOR LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The interior light control illuminates the lights below.
  1. Power Switch Illumination
  2. Personal Light
  3. Rear Interior Light

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Fade in and illuminate constantly
    Any door is opened when all doors are closed.
    Illuminate for 15 seconds, and then fade out
    When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
    1. The key enters any actuation area around the doors when the power switch is off and all doors are closed*1.
    2. Any door is unlocked when the power switch is off with all doors closed and locked.
    3. The power switch is turned from on (IG) to off when all doors are closed.
    4. All doors are closed after any door is opened and the power switch off.
    Fade out immediately
    When any of the following conditions is met, the lights fade out immediately:
    1. The power switch is turned from off to on (ACC) when all doors are closed.
    2. All doors are locked when the power switch is off, all doors are closed and any door is unlocked.
    3. All doors are locked again when all doors are already closed and locked.

    1. *1: When the lights are on, if the key leaves all of the actuation areas around the doors, after approximately 3 seconds, the lights fade out.


INSPECT INSIDE HANDLE ILLUMINATION LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Fade in and illuminate constantly
    When either of the following conditions is met, the inside handle illumination lights fade in:
    1. Any door is opened when all doors are closed.
    2. The power switch is turned from off to on (IG).
    Illuminate for 15 seconds, and then fade out
    When any of the following conditions is met, the inside handle illumination lights illuminate for 15 seconds and then fade out:
    1. Any door is unlocked when the power switch is off, all doors are closed and all doors are locked.
    2. The power switch is turned from on (IG) to off when all doors are closed.
    3. All doors are closed when any door is opened and the power switch is off.
    Fade out immediately
    When any of the following conditions is met, the lights fade out immediately:
    1. All doors are locked when the power switch is off, all doors are closed and any door is unlocked.
    Dim
    When the power switch is on (IG) and the shift lever is moved out of P, the lights that operate dim.


INSPECT FOOTWELL LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Fade in and illuminate constantly
    When either of the following conditions is met, the inside handle illumination lights fade in:
    1. Any door is opened when all doors are closed.
    2. The power switch is turned from off to on (IG).
    Illuminate for 15 seconds, and then fade out
    When any of the following conditions is met, the inside handle illumination lights illuminate for 15 seconds and then fade out:
    1. Any door is unlocked when the power switch is off, all doors are closed and all doors are locked.
    2. The power switch is turned from on (IG) to off when all doors are closed.
    3. All doors are closed when any door is opened and the power switch is off.
    Fade out immediately
    When any of the following conditions is met, the lights fade out immediately:
    1. All doors are locked when the power switch is off, all doors are closed and any door is unlocked.
    Dim
    When the power switch is on (IG) and the shift lever is moved out of P, the lights that operate dim.


BATTERY SAVING CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The lights controlled by battery saving control are as follows:
  1. Power Switch Illumination
  2. Personal Light
  3. Rear Interior Light
  4. Inside Handle Illumination Light
  5. Footwell Light
  6. Courtesy Light
  7. Luggage Compartment Light
  8. Vanity Light

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Battery saving
    When 20 minutes elapse after the power switch is turned from on (ACC) or on (IG) to off and the lights that operate remain on, the lights are turned off.

    HINT:
    Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
    1. The power switch is turned on (ACC) or on (IG)
    2. Any door is opened and closed
    3. The luggage compartment door is opened and closed
    4. Any door is unlocked
    5. The key enters any exterior actuation area