Home › Engine / Hybrid System › 2AR-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


4. REMOVE ENGINE UNDER COVER LH


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A259044
  1. Disconnect the heated oxygen sensor connector.



    A258884
  1. Remove the 2 bolts, 2 compression springs and 2 nuts.

  1. Remove the front exhaust pipe assembly from the exhaust pipe support.

  1. Remove the 2 gaskets from the exhaust manifold converter sub-assembly and front exhaust pipe assembly.



6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A209579
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator.



7. REMOVE AIR FUEL RATIO SENSOR


    A254802
  1. Remove the hose clamp.

  1. Disconnect the air fuel ratio sensor connector.



    A254803E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold.

    SST
    09224-00010  



8. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    A257337
  1. Remove the 3 bolts and No. 1 manifold converter insulator.



9. REMOVE NO. 2 MANIFOLD STAY


    A257340
  1. Remove the bolt, nut and No. 2 manifold stay.



10. REMOVE MANIFOLD STAY


    A257339
  1. Remove the bolt, nut and manifold stay.



11. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    A195979
  1. Remove the 5 nuts and exhaust manifold converter sub-assembly.



    A195981
  1. Remove the gasket.



12. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A211654
  1. Remove the 2 bolts and No. 2 exhaust manifold heat insulator.