Home › Engine / Hybrid System › 2AR-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


4. REMOVE ENGINE UNDER COVER LH


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)


    A259044
  1. Disconnect the heated oxygen sensor connector.



    A258884
  1. Remove the 2 bolts, 2 compression springs and 2 nuts.

  1. Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust pipe support.

  1. Remove the 2 gaskets from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and front exhaust pipe assembly (TWC: Rear Catalyst).



6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A209579
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).



7. REMOVE AIR FUEL RATIO SENSOR


    A254802
  1. Remove the hose clamp.

  1. Disconnect the air fuel ratio sensor connector.



    A254803E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold.

    SST
    09224-00010  



8. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    A257337
  1. Remove the 3 bolts and No. 1 manifold converter insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).



9. REMOVE NO. 2 EGR PIPE (w/ EGR System)


    A257338
  1. Remove the 2 bolts, 2 nuts and No. 2 EGR pipe from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and EGR cooler assembly.

  1. Remove the 2 gaskets from the No. 2 EGR pipe.



10. REMOVE NO. 2 MANIFOLD STAY


    A257340
  1. Remove the bolt, nut and No. 2 manifold stay from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and stiffening crankcase assembly.



11. REMOVE MANIFOLD STAY


    A257339
  1. Remove the bolt, nut and manifold stay from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and stiffening crankcase assembly.



12. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst)


    A195979
  1. Remove the 5 nuts and exhaust manifold converter sub-assembly (TWC: Front Catalyst) from the cylinder head sub-assembly.



    A195981
  1. Remove the gasket from the cylinder head sub-assembly.



13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A211654
  1. Remove the 2 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).