FRONT BRAKE FLEXIBLE HOSE > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD) |
| 3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD) |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 4. DISABLE BRAKE CONTROL (for LHD) |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 5. DISABLE BRAKE CONTROL (for RHD) |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 6. REMOVE FRONT WHEEL |
| 7. DRAIN BRAKE FLUID |
| 8. REMOVE FRONT FLEXIBLE HOSE |
![]() |
Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.
![]() |
Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.
| *1 | Clip |
Remove the clip.
![]() |
Remove the bolt and front flexible hose from the front shock absorber assembly.