Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)

BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT

HINT:
Use the same procedure for LHD and RHD (Click here).



2. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C242724
  1. Disconnect the connector from the brake pedal stroke sensor assembly.



    C242725
  1. Remove the 2 bolts and brake pedal stroke sensor assembly from the brake pedal support assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.



3. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY


    E226686E01
  1. Disconnect the connector.

  1. Disengage the clamp.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide

  1. Remove the bolt.

  1. Disengage the 2 guides and remove the headlight leveling ECU assembly.



4. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E226682
  1. Disconnect the connector.



    E226683
  1. Turn the stop light switch assembly counterclockwise and remove it.



5. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


6. REMOVE PUSH ROD PIN


    C243045
  1. Remove the clip and push rod pin.

  1. Separate the brake master cylinder push rod clevis from the brake pedal support assembly.



7. REMOVE BRAKE PEDAL RETURN SPRING


    C243047
  1. Remove the brake pedal return spring from the brake pedal support assembly.



8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C249088
  1. Disengage the 3 clamps and separate the wire harness from the brake pedal support assembly.



    C242729
  1. Disengage the clamp and separate the wire harness from the brake pedal support assembly.



    C249087
  1. Remove the 4 nuts and brake pedal support assembly.