Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    E289126E09
  1. Disconnect the T16 rear combination light assembly LH connector.

  1. Apply battery voltage to the rear combination light assembly LH and check that the lights come on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T16-2 (TL)
    Battery negative (-) → T16-3 (E)
    Taillight comes on
    Battery positive (+) → T16-1 (B)
    Battery negative (-) → T16-3 (E)
    Stop light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Assembly LH)
    If the result is not as specified, replace the rear combination light lens and body LH.



2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    E289126E11
  1. Disconnect the T17 rear combination light assembly RH connector.

  1. Apply battery voltage to the rear combination light assembly LH and check that the lights come on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T17-2 (TL)
    Battery negative (-) → T17-3 (E)
    Taillight comes on
    Battery positive (+) → T17-1 (B)
    Battery negative (-) → T17-3 (E)
    Stop light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Assembly RH)
    If the result is not as specified, replace the rear combination light lens and body RH.