Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT REAR LIGHT ASSEMBLY LH


    E289126E05
  1. Disconnect the T7 rear light assembly LH connector.

  1. Apply battery voltage to the rear light assembly LH and check that the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T7-2 (B)
    Battery negative (-) → T7-3 (E)
    Taillight comes on

    If the result is not as specified, replace the rear light lens and body LH or rear light socket and wire LH.

  1. Apply battery voltage to the rear light assembly LH and check that the light comes on. (w/ Rear Fog Light)

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T7-4 (B)
    Battery negative (-) → T7-3 (E)
    Rear fog light comes on

    If the result is not as specified, replace the rear fog light bulb or rear light socket and wire LH.

  1. Apply battery voltage to the rear light assembly LH and check that the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T7-1 (B)
    Battery negative (-) → T7-3 (E)
    Back-up light comes on

    Text in Illustration 
    *A
    w/ Rear Fog Light
    *a
    Component without harness connected
    (Rear Light Assembly LH)
    If the result is not as specified, replace the back-up light bulb or rear light socket and wire LH.



2. INSPECT REAR LIGHT ASSEMBLY RH


    E289126E07
  1. Disconnect the T1 rear light assembly RH connector.

  1. Apply battery voltage to the rear light assembly RH and check that the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T1-2 (B)
    Battery negative (-) → T1-3 (E)
    Taillight comes on

    If the result is not as specified, replace the rear light lens and body RH or rear light socket and wire RH.

  1. Apply battery voltage to the rear light assembly RH and check that the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T1-4 (B)
    Battery negative (-) → T1-3 (E)
    Rear fog light comes on

    If the result is not as specified, replace the rear fog light bulb or rear light socket and wire RH.

  1. Apply battery voltage to the rear light assembly RH and check that the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → T1-1 (B)
    Battery negative (-) → T1-3 (E)
    Back-up light comes on

    Text in Illustration 
    *A
    w/ Rear Fog Light
    *a
    Component without harness connected
    (Rear Light Assembly RH)
    If the result is not as specified, replace the back-up light bulb or rear light socket and wire RH.