Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH

HEADLIGHT CLEANER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY


    E136319E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    I9-1 (L) - I9-4 (B)
    Headlight cleaner switch on
    Below 1 Ω
    Headlight cleaner switch off
    10 kΩ or higher

  1. Connect a auxiliary battery positive (+) lead to terminal I9-3 (ILL+) and a negative (-) lead to terminal I9-2 (ILL-).

  1. Check that the headlight cleaner switch assembly illumination comes on.

    OK:
    The headlight cleaner switch assembly illumination comes on.

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Switch Assembly)
    If the result is not as specified, replace the headlight cleaner switch assembly.