Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR SENSOR

SOLAR SENSOR > INSPECTION

for Preparation Click here



1. INSPECT SOLAR SENSOR (AUTOMATIC LIGHT CONTROL SENSOR)


    E221132E17
  1. Disconnect the solar sensor (automatic light control sensor) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I61-6 (CLTB) - I61-3 (CLTE)
    Power switch off
    Below 1 V
    I61-6 (CLTB) - I61-3 (CLTE)
    Power switch on (IG)
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Solar Sensor (Automatic Light Control Sensor))
    If the voltage is not as specified, repair or replace the wire harness or connector.



    E221134E23
  1. Reconnect the solar sensor (automatic light control sensor) connector.

  1. Turn the power switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I61-1 (TSL) - I61-3 (CLTE)
    Sensor is exposed to electric light
    0.8 to 4.3 V
    I61-1 (TSL) - I61-3 (CLTE)
    Sensor is covered with a cloth
    Below 0.8 V
    I61-2 (TSR) - I61-3 (CLTE)
    Sensor is exposed to electric light
    0.8 to 4.3 V
    I61-2 (TSR) - I61-3 (CLTE)
    Sensor is covered with a cloth
    Below 0.8 V

    Text in Illustration 
    *a
    Component with harness connected
    (Solar Sensor (Automatic Light Control Sensor))
    If the voltage is not as specified, replace the solar sensor (automatic light control sensor).

    NOTICE:
    1. The connection procedure for using a digital tester such as a TOYOTA electrical tester is shown above. When using an analog tester, connect the positive (-) lead to terminal 1 (2) and the negative (+) lead to terminal 6 of the automatic light control sensor (solar sensor).
    2. Do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    HINT:
    1. Use an incandescent light for inspection. Bring it within about 30 cm (11.8 in.) of the solar sensor (automatic light control sensor).
    2. As the inspection light is moved away from the sensor, the voltage decreases.