Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP

SERVICE PLUG GRIP > INSTALLATION

for Preparation Click here



1. INSTALL SERVICE PLUG GRIP

CAUTION:
Wear insulating gloves.

NOTICE:
Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.



  1. Wear insulated gloves and install the service plug grip in the order shown in the illustration.


    A258775

  1. Rotate the handle of the service plug grip 90° toward the battery and slide it in the direction shown by the arrow until a click sound is heard.



2. INSTALL NO. 8 HYBRID VEHICLE BATTERY SHIELD PANEL
  1. Install the No. 8 hybrid vehicle battery shield panel with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



3. INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER
  1. Engage the 2 claws.

  1. Engage the 8 fasteners and install the luggage compartment front trim cover.



4. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



5. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.



6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


7. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
  1. Engage the claw to connect the luggage trim service hole cover.