STEERING WHEEL > INSTALLATION |
| 1. INSTALL STEERING SHAKE DAMPER |
Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
| 2. INSTALL LOWER STEERING WHEEL BOSS COVER |
Engage the 6 claws and 2 guides to install the lower steering wheel boss cover to the steering wheel sub-assembly.
| 3. INSTALL CRUISE CONTROL SWITCH WIRE |
Install the cruise control switch wire.
| 4. INSTALL CRUISE CONTROL MAIN SWITCH |
Connect the connector.
![]() |
Install the cruise control main switch with the 2 screws shown in the illustration.
| 5. INSTALL STEERING PAD SWITCH ASSEMBLY |
Engage the claw and 2 pins to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.
Install the 2 screws.
Engage the claw and 2 pins to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.
Install the 2 screws.
Connect the steering pad switch connector to the spiral cable sub-assembly.
![]() |
Pass the wire harness over the 2 guides.
| 6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Check if the spiral cable with sensor sub-assembly is centered.
![]() | Colored Part |
If the spiral cable with sensor sub-assembly is not centered, center it.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
![]() | Colored Part |
![]() | Interlock |
| 8. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
| *a | Matchmark |
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 9. CHECK STEERING WHEEL CENTER POINT |
| 10. INSTALL HORN BUTTON ASSEMBLY |