Home › Steering › STEERING COLUMN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the claw and 2 pins to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Engage the claw and 2 pins to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the steering pad switch connector to the spiral cable sub-assembly.



    C239353
  1. Pass the wire harness over the 2 guides.



2. INSTALL HORN BUTTON ASSEMBLY
(Click here)