Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSTALLATION

for Preparation Click here


NOTICE:
  1. Do not replace the spiral cable with the auxiliary battery connected and the power switch on (IG).
  2. Do not rotate the spiral cable without the steering wheel with the auxiliary battery connected and the power switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



1. INSTALL STEERING SHAKE DAMPER
  1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }



2. INSTALL CRUISE CONTROL SWITCH WIRE
  1. Install the cruise control switch wire.



3. INSTALL CRUISE CONTROL MAIN SWITCH
  1. Connect the connector.



    E226402
  1. Install the cruise control main switch with the 2 screws shown in the illustration.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }



4. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Engage the clamp.

  1. Connect the steering pad switch connector to the spiral cable sub-assembly.



    C279318
  1. Pass the wire harness over the 2 guides.



5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


6. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
  2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    If it is not in the neutral position, the turn signal switch pin may snap.

  1. Engage the 3 claws to install the spiral cable with sensor sub-assembly.

  1. Connect the each connector.



7. INSTALL STEERING WHEEL ASSEMBLY


    C310282E01
  1. Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
    Text in Illustration 
    *a
    Matchmark

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.



8. CHECK STEERING WHEEL CENTER POINT


9. INSTALL HORN BUTTON ASSEMBLY
(Click here)