Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3110-223    HV Main Relay

for Preparation Click here


DESCRIPTION

The power management control ECU monitors the IGCT relay and detects the following malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3110
223
There is a short to +B in the IGCT relay or the IGCT relay is stuck closed.
  1. Wire harness or connector
  2. IGCT relay
  3. Power management control ECU

WIRING DIAGRAM


A264606E01


INSPECTION PROCEDURE

HINT:
If the auxiliary battery voltage is applied to terminal +B1 or +B2 of the power management control ECU, even though the power switch is off, the circuit is shorted to +B.

1.INSPECT RELAY (IGCT)
  1. Remove the IGCT relay from the No. 2 engine room relay block.



    A253297E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Auxiliary battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher

    Text in Illustration 
    *1
    IGCT Relay

  1. Install the IGCT relay.



NG
REPLACE RELAY (IGCT)
OK


2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - NO.2 ENGINE ROOM RELAY BLOCK)
  1. Remove the IGCT relay from the No. 2 engine room relay block.

  1. Disconnect connector A38 and A39 from the power management control ECU.



  1. Measure the voltage according to the value(s) in the table below.


    A259914E01


    Text in Illustration 
    *1
    No. 2 Engine Room Relay Block
    *2
    IGCT relay
    *a
    Rear view of wire harness connector
    (to Power Management Control ECU)
    -
    -

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A39-5 (+B1), A38-2 (+B2) or 5 (IGCT relay) - Body ground
    Power switch off
    Below 1 V

  1. Install the IGCT relay.

  1. Connect the power management control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)