Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER ASSEMBLY
  1. Connect the headlight cleaner hose.

  1. Move the front bumper assembly into position and install the 3 clips.

  1. Install the 2 screws.

  1. Pull back the side of the front bumper assembly and connect each connector.

    NOTICE:
    Do not apply excessive force when separating the front bumper.



    B298692
  1. Engage the 3 claws to install the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 8 screws.



    B292891E01
  1. Install the pin hold clip as shown in the illustration.
    Text in Illustration 
    *1
    Pin Hold Clip
    *a
    Correct
    *b
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 9 clips.



3. ADD WASHER FLUID
  1. Add washer fluid to the washer jar.



4. ADJUST FOG LIGHT ASSEMBLY
(Click here)