Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER PLATE LH


    B382660E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws.
    Text in Illustration 
    *a
    Hook
    V100155
    Protective Tape

  1. Disengage the hook and remove the rear bumper plate LH.



2. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER ASSEMBLY


    B382662
  1. Apply protective tape around the rear bumper assembly.
    Text in Illustration 
    V100155
    Protective Tape



    B382663
  1. Remove the 6 screws.

  1. Using a clip remover, remove the 4 clips.



    B382664
  1. Remove the 2 screws.

    HINT:
    Use the same procedure for the RH side and LH side.



    B382665
  1. Disengage the 7 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B382667
  1. Disengage the 6 claws as shown in the illustration.

  1. Disconnect the connector.

  1. Remove the rear bumper assembly.