WASHER MOTOR > REMOVAL |
| 1. REMOVE FRONT WHEEL RH |
| 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
![]() |
Remove the 3 screws and front wheel opening extension pad RH.
| 3. REMOVE FRONT FENDER LINER RH |
![]() |
Remove the clip.
![]() |
Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.
| *a | 90° |
![]() |
Remove the 5 screws.
| *1 | Grommet |
Remove the 4 clips, 2 grommets and front fender liner RH.
| 4. DRAIN WASHER FLUID |
![]() |
Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
| 5. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
![]() |
Disconnect the connector.
Remove the windshield washer motor and pump assembly as shown in the illustration.