Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Check for DTCs (Click here).

    NOTICE:
    The radio and display receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
    System
    Proceed to
    Audio and Visual System
    Click here


CLEAR DTC
  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Clear the DTCs.