DTC B2322 Front Passenger Side Door ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2322 | No communication between power window regulator motor assembly (for front passenger door) and main body ECU (multiplex network body ECU) for 10 seconds or more. |
|

| 1.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).

Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-30 (LIN2) - MB-16 (LIN2) | Always | Below 1 Ω |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | *b | Component without harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - POWER WINDOW REGULATOR MOTOR) |
Disconnect the J9*1 or K9*2 power window regulator motor assembly (for front passenger door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-30 (LIN2) - J9-9 (LIN)*1 3B-30 (LIN2) - K9-9 (LIN)*2 | Always | Below 1 Ω |
| 3B-30 (LIN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR - AUXILIARY BATTERY, BODY GROUND) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J9-2 (B) - Body ground*1 K9-2 (B) - Body ground*2 | Power switch off | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J9-1 (GND) - Body ground*1 K9-1 (GND) - Body ground*2 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER DOOR) |
Replace the power window regulator motor assembly (for front passenger door) (Click here).
| NEXT | |
| 5.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Check for DTCs.
|
| ||||
| OK | ||
| ||