REAR BUMPER > REASSEMBLY |
| 1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY |
![]() |
Install the rear bumper reinforcement sub-assembly with the 6 nuts.
| 2. INSTALL WHEEL HOUSE REINFORCEMENT LH |
![]() |
Engage the clip.
Install the wheel house reinforcement LH with the screw and nut.
| 3. INSTALL WHEEL HOUSE REINFORCEMENT RH |
| 4. INSTALL REAR BUMPER SIDE RETAINER LH |
![]() |
Engage the 6 claws.
Install the rear bumper side retainer LH with the 3 screws.
| 5. INSTALL REAR BUMPER SIDE RETAINER RH |
| 6. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System) |
![]() |
Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.
| *A | LH Side |
| *B | RH Side |
| *a | Keyhole |
| *b | Snap |
| 7. INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System) |
![]() |
Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.
| *A | LH Side |
| *B | RH Side |
| 8. INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System) |
![]() |
Engage the 4 claws to install the ultrasonic sensor clip.
| *A | LH Side |
| *B | RH Side |
![]() |
Engage the clamp.
| *A | LH Side |
| *B | RH Side |
Connect the connector.
| 9. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System) |
![]() |
Connect the 4 connectors.
Engage the 4 clamps to install the No. 2 luggage room wire.
| 10. INSTALL REFLEX REFLECTOR ASSEMBLY LH |
![]() |
Engage the guide.
Install the reflex reflector assembly LH with the screw.
| 11. INSTALL REFLEX REFLECTOR ASSEMBLY RH |
| 12. INSTALL REAR BUMPER PAD LH |
Wipe off any tape adhesive residue with cleaner.
![]() |
Install a new rear bumper pad LH.
| 13. INSTALL REAR BUMPER PAD RH |
Wipe off any tape adhesive residue with cleaner.
![]() |
Install a new rear bumper pad RH.