Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
  1. Engage the 2 claws to install the back sonar or clearance sonar switch assembly.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B280330
  1. Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

  1. Connect each connector.

  1. for LHD:

    1. Engage the 3 claws, 7 clips and 4 guides.

  1. for RHD:

    1. Engage the 4 claws, 5 clips and 4 guides.



    B283375
  1. Engage the 4 clips and 2 guides to install the instrument cluster finish panel assembly.



3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

HINT:
Use the same procedure as for the LH side .



4. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL
  1. Connect the connector.



    B287369
  1. Engage the 2 claws and 4 clips to install the upper instrument panel finish panel.



5. INSTALL INSTRUMENT SIDE PANEL RH


    B281766
  1. Engage the 3 guides as shown in the illustration.



    B281764
  1. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B278981E01
  1. Align the alignment mark (White) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.
    Text in Illustration 
    *1
    Alignment Mark (White)

    NOTICE:
    After installation, check that the corners fit correctly.



7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
  1. Engage the claw to connect the luggage trim service hole cover.