Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B284920
  1. Disconnect the front door opening trim weatherstrip RH.



5. REMOVE INSTRUMENT SIDE PANEL RH


    B281763
  1. Using moulding remover, disengage the 4 claws as shown in the illustration.



    B281765
  1. Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.



6. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL


    B287390
  1. Disengage the 2 claws and 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the upper instrument panel finish panel.



7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

HINT:
Use the same procedure as for the LH side .



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    B283374
  1. Using a moulding remover, disengage the 4 clips and 2 guides.



  1. for LHD:



      B280326
    1. Disengage the 3 claws, 7 clips and 4 guides.



  1. for RHD:



      B292377
    1. Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.

  1. Disconnect each connector.



    B280329
  1. Remove the instrument cluster finish panel assembly as shown in the illustration.



9. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


    E228724
  1. Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.