Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH

VSC OFF SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 SWITCH HOLE BASE


    E235169E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, disengage the 4 claws and 2 guides as shown in the illustration.

  1. Disconnect the connector and remove the No. 1 switch hole base.



2. REMOVE VEHICLE STABILITY CONTROL SWITCH (for LHD)


    C268163
  1. Disengage the 2 claws to remove the vehicle stability control switch.



3. REMOVE VEHICLE STABILITY CONTROL SWITCH (for RHD)


    C268164
  1. Disengage the 2 claws to remove the vehicle stability control switch.