Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for RHD)


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for RHD)


4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B298720
  1. Disconnect the front door opening trim weatherstrip LH.



5. REMOVE INSTRUMENT SIDE PANEL


    B280320
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B280322
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



6. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)


    B287390
  1. Disengage the 2 claws and 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the upper instrument panel finish panel.



7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B280324
  1. Disengage the 4 clips to remove the No. 1 instrument panel register assembly as shown in the illustration.



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    B283374
  1. Using a moulding remover, disengage the 4 clips and 2 guides.



  1. for LHD:



      B280326
    1. Disengage the 3 claws, 7 clips and 4 guides.



  1. for RHD:



      B292377
    1. Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.

  1. Disconnect each connector.



    B280329
  1. Remove the instrument cluster finish panel assembly as shown in the illustration.



9. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


  1. for LHD:



      E228723
    1. Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.



  1. for RHD:



      E228724
    1. Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.