Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > INSTALLATION

for Preparation Click here



1. INSTALL WASHER NOZZLE SUB-ASSEMBLY
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E226461E01
  1. Engage the 2 claws to install the washer nozzle sub-assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the power switch on (READY), check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E226091E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    300.0 mm (11.8 in.)
    B
    145.0 mm (5.71 in.)
    C
    170.0 mm (6.69 in.)
    -
    -

    Text in Illustration 
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    -
    -

    HINT:
    If the result is not as specified, replace the washer nozzle sub-assembly.



3. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.


    E226092E03


    Text in Illustration 
    *a
    Washer Fluid Spray Angle
    *b
    Part Number