ROOM TEMPERATURE SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER |
![]() |
Disengage the claw to remove the luggage trim service hole cover.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 2 claws (A) in the direction indicated by the arrows (1) shown in the illustration.
Disengage the 2 claws (B) in the direction indicated by the arrows (2) shown in the illustration.
Disengage the 6 claws (C) to remove the front door scuff plate LH.
| 5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY |
![]() |
Remove the clip.
Pull the cowl side trim sub-assembly LH in the direction indicated by the arrow shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 7. REMOVE INSTRUMENT SIDE PANEL |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 8. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD) |
![]() |
Disengage the 2 claws and 4 clips as shown in the illustration.
Disconnect the connector to remove the upper instrument panel finish panel.
| 9. REMOVE FRONT PANEL GARNISH |
![]() |
Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.
| 10. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.
| 11. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 bolts <B>.
![]() |
Disengage the 5 clips and 3 guides to remove the instrument panel sub-assembly.
| 12. REMOVE ROOM TEMPERATURE SENSOR |
![]() |
Disengage the 2 claws as shown in the illustration.
Disconnect the hose and connector and remove the room temperature sensor.