Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR

ROOM TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



4. REMOVE FRONT DOOR SCUFF PLATE


    B395175E01
  1. Disengage the 2 claws (A) in the direction indicated by the arrows (1) shown in the illustration.

  1. Disengage the 2 claws (B) in the direction indicated by the arrows (2) shown in the illustration.

  1. Disengage the 6 claws (C) to remove the front door scuff plate LH.



5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY


    B278978
  1. Remove the clip.

  1. Pull the cowl side trim sub-assembly LH in the direction indicated by the arrow shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.



6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B298720
  1. Disconnect the front door opening trim weatherstrip LH.



7. REMOVE INSTRUMENT SIDE PANEL


    B280320
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B280322
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



8. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)


    B287390
  1. Disengage the 2 claws and 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the upper instrument panel finish panel.



9. REMOVE FRONT PANEL GARNISH


    B384406
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



10. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B279865
  1. Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.



11. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY


    B384407
  1. Remove the 2 bolts <B>.



    B386777
  1. Disengage the 5 clips and 3 guides.

  1. Disconnect each connector to remove the instrument panel sub-assembly



12. REMOVE ROOM TEMPERATURE SENSOR


    E228089
  1. Disengage the 2 claws as shown in the illustration.

  1. Disconnect the hose and connector and remove the room temperature sensor.