Home › Vehicle Interior › LIGHTING (INT) › REAR DOOR COURTESY SWITCH

REAR DOOR COURTESY SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B298856E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



2. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the LH side and RH side.



3. REMOVE REAR SIDE SEATBACK ASSEMBLY
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide LH.



    B285000
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



4. REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Disconnect the connector.



    E226719
  1. Using a T30 "TORX" socket wrench, remove the screw and rear door courtesy light switch assembly.