Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
(Click here)


2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E227541
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the license plate light assembly.



3. REMOVE LICENSE PLATE LIGHT BULB


    E255008E02
  1. Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it in the direction shown in the illustration and disengage the 2 claws to remove the license plate light lens.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Insert into the hole



    E255009
  1. Remove the license plate light bulb.