Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    E227547
  1. Disconnect the connector.

  1. Remove the 3 nuts and rear height control sensor sub-assembly.

    NOTICE:
    Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.