Home › Vehicle Exterior › WIPER / WASHER › WIPER ECU

WIPER ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT PANEL GARNISH


    B280332
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH as shown in the illustration.



2. REMOVE FRONT DOOR SCUFF PLATE

HINT:
Use the same procedure as for the LH side .



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side .



4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B284920
  1. Disconnect the front door opening trim weatherstrip RH.



5. REMOVE INSTRUMENT SIDE PANEL


    B281763
  1. Using moulding remover, disengage the 4 claws as shown in the illustration.



    B281765
  1. Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.



6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B279888
  1. Disengage the 4 claws.

  1. Disengage the 2 guides.

  1. Disconnect the connector to remove the No. 2 instrument panel under cover sub-assembly.



7. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B281767
  1. Remove the bolt <B> and screw <C>.

  1. Open the lower instrument panel door.



    B281768
  1. Remove the 3 screws <C>.



    B281769
  1. Disengage the 2 clips, 4 guides and remove the lower instrument panel sub-assembly as shown in the illustration.



8. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY


    E227783
  1. Disconnect the connector.

  1. Remove the nut and windshield wiper relay assembly.