Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE BACK-UP LIGHT BULB


    E301901
  1. Turn the rear light socket and wire with the back-up light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.

  1. Remove the back-up light bulb from the rear light socket and wire.



2. REMOVE NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light)


    E301904
  1. Turn the rear light socket and wire with the No. 1 rear fog light bulb in the direction indicated by the arrow shown in the illustration and remove them as a unit.

  1. Remove the No. 1 rear fog light bulb from the rear light socket and wire.



3. REMOVE REAR LIGHT SOCKET AND WIRE


    E301907
  1. Disconnect connector to remove the rear light socket and wire.



4. REMOVE REAR LIGHT GASKET


    E301903
  1. Remove the rear light gasket.

    NOTICE:
    1. Be sure to remove all the traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear light gasket to prevent water ingress.