Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1440/98    Unusual Bank Angle Detected

for Preparation Click here


DESCRIPTION

If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440/98 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1440/98
-
Driving at a steep bank angle.
  1. Yaw rate and acceleration sensor (for separate type)
  2. Yaw rate and acceleration sensor (Airbag sensor assembly) (for built-in type)

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC C1440/98 is output.
    A
    DTC C1440/98 is not output.
    B
    Yaw rate and acceleration sensor DTC is output.
    C



B
END

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.CLEAR DTC
  1. Clear the DTCs (Click here).

    HINT:
    1. If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440/98 while VSC operation is temporarily disabled.
    2. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.


NEXT

END