CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the intake valve guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05), and measure its diameter.
Machine the bush bore of the cylinder head to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| STD | 10.333 to 10.344 mm (0.4068 to 0.4072 in.) |
| O/S 0.05 | 10.383 to 10.394 mm (0.4088 to 0.4092 in.) |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in the selected guide bush to the standard protrusion height.
| *a | Height |
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard oil clearance between the guide bush and valve stem.
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the exhaust valve guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05), and measure its diameter.
Machine the bush bore of the cylinder head to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| STD | 10.333 to 10.344 mm (0.4068 in 0.4072 in.) |
| O/S 0.05 | 10.383 to 10.394 mm (0.4088 to 0.4092 in.) |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in the selected guide bush to the standard protrusion height.
| *a | Height |
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard oil clearance between the guide bush and valve stem.
| 3. REPLACE RING PIN |
Remove the ring pins.
![]() |
Using a plastic-faced hammer, tap in 2 new ring pins to the cylinder head.