Home › Engine / Hybrid System › 2AR-FXE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR ENGINE OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.

    NOTICE:
    1. Do not allow foreign matter to contact the lip of the oil seal.
    2. Do not allow MP grease to contact the dust seal.



    A195810E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    NOTICE:
    1. Keep the lip of the oil seal free from foreign matter.
    2. Do not tap in the oil seal at an angle.



2. INSTALL FLYWHEEL SUB-ASSEMBLY


    A195875E06
  1. Using SST, hold the crankshaft.

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



    A192239E03
  1. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A259955E02
  1. Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

    Torque:
    130 N*m{ 1325 kgf*cm , 96 ft.*lbf }

    NOTICE:
    Do not start the engine for at least an hour after installing the flywheel sub-assembly.

  1. Check that the crankshaft turns smoothly.



3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY


    A195875E06
  1. Using SST, hold the crankshaft.

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)

  1. Install the transmission input damper.



    A260502E02
  1. Install and uniformly tighten the 6 bolts in the sequence shown in the illustration.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    1. Take care not to insert the transmission input damper in the wrong direction.



4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY