Home › Engine / Hybrid System › 2AR-FXE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    A195875E06
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



    A260502
  1. Remove the 6 bolts and transmission input damper assembly.



3. REMOVE FLYWHEEL SUB-ASSEMBLY


    A195875E06
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



    A259955
  1. Remove the 8 bolts and flywheel sub-assembly.



4. REMOVE REAR ENGINE OIL SEAL


    A195809E04
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.