INSTRUMENT PANEL SAFETY PAD > REASSEMBLY |
| 1. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY |
![]() |
Engage the 14 clips.
![]() |
Install the No. 2 instrument panel garnish sub-assembly with the 2 screws <C>.
| 2. INSTALL NO. 2 HEATER TO REGISTER DUCT |
![]() |
Install the No. 2 heater to register duct with the 2 screws <C>.
| 3. INSTALL DEFROSTER NOZZLE ASSEMBLY |
![]() |
Engage the 2 guides.
Install the defroster nozzle assembly with the 3 screws <C>.
| 4. INSTALL ANTENNA CORD SUB-ASSEMBLY (for LHD) |
Engage the 8 clamps to install the antenna cord sub-assembly.
| 5. INSTALL ANTENNA CORD SUB-ASSEMBLY (for RHD) |
Engage the 10 clamps to install the antenna cord sub-assembly.
| 6. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Engage the 2 claws.
Install the No. 2 side defroster nozzle duct with the screw <C>.
| 7. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Engage the 2 claws.
Install the No. 1 side defroster nozzle duct with the screw <C>.
| 8. INSTALL ION GENERATOR SUB-ASSEMBLY WITH BRACKET |
Install the ion generator sub-assembly with bracket with the 3 screws.
| 9. INSTALL NO. 3 HEATER TO REGISTER DUCT (for LHD) |
![]() |
Install the No. 3 heater to register duct with the 3 screws <C>.
Install the clip.
| 10. INSTALL HEATER TO REGISTER DUCT ASSEMBLY (for RHD) |
Engage the heater to register duct assembly to the ion generator assembly.
![]() |
Install the heater to register duct assembly with the 3 screws <C>.
Install the clip.
| 11. INSTALL HEATER TO REGISTER DUCT ASSEMBLY (for LHD) |
Engage the heater to register duct assembly to the ion generator assembly.
![]() |
Install the heater to register duct assembly with the 3 screws <C>.
Install the clip.
| 12. INSTALL NO. 1 HEATER TO REGISTER DUCT (for RHD) |
![]() |
Install the No. 1 heater to register duct with the 3 screws <C>.
Install the clip.
| 13. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
![]() |
Engage the 3 hooks as shown in the illustration.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
| 14. INSTALL NO. 1 INSTRUMENT PANEL PIN |
Install the 4 No. 1 instrument panel pins with the 4 screws <C>.
