Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HEATER CONTROL SWITCH BOARD

NOTICE:
When resassembling the air conditioning control assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.



    E228096
  1. Install the heater control base sub-assembly with the 5 screws.



2. INSTALL HEATER CONTROL HOUSING SUB-ASSEMBLY


    E232143
  1. Engage the 4 claws.

  1. Install the heater control housing sub-assembly to the heater control retainer RH with the 3 screws.



3. INSTALL AIR CONDITIONING PANEL SUB-ASSEMBLY


    E234926
  1. Engage the 7 claws.



    E234925
  1. Install the air conditioner panel sub-assembly with the 2 screws.



4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)


    E235264
  1. Engage the guide and 4 clips to install the air conditioning control assembly as shown in the illustration.



5. INSTALL NO. 1 RADIO BRACKET
  1. Install the No. 1 radio bracket with the 5 screws.



6. INSTALL NO. 2 RADIO BRACKET
  1. Install the No. 2 radio bracket with the 5 screws.



7. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
  1. Connect each connector.

  1. Engage the 6 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

  1. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.



8. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
  1. Connect each connector.



    B292379
  1. Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.



9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
  1. Connect the connector.



    B281760
  1. Engage the 4 clips to install the No. 2 instrument panel register assembly.

    NOTICE:
    When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.



10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B283351
  1. Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.



11. INSTALL FRONT PANEL GARNISH RH


    B280333
  1. Engage the 3 clips and 8 guides to install the front panel garnish RH.



12. INSTALL FRONT PANEL GARNISH LH


    B281945
  1. Engage the 3 clips and 8 guides to install the front panel garnish LH.



13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


14. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
  1. Engage the claw to connect the luggage trim service hole cover.