Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE FRONT PANEL GARNISH LH


    B280331
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



5. REMOVE FRONT PANEL GARNISH RH


    B280332
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH as shown in the illustration.



6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B281758
  1. Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.



    B281757
  1. Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.



7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    B281759
  1. Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 2 instrument panel register assembly.



8. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


    B292378
  1. Disengage the 2 claws as shown in the illustration.

  1. Disconnect each connector to remove the front console upper panel garnish.



9. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    E227930E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    E227932
  1. Remove the 4 bolts.



    E227934
  1. Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 6 clips.

  1. Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.



10. REMOVE NO. 1 RADIO BRACKET


    E227935
  1. Remove the 5 screws and No. 1 radio bracket.



11. REMOVE NO. 2 RADIO BRACKET


    E230758
  1. Remove the 5 screws and No. 2 radio bracket.



12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)


    E235263
  1. Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.



13. REMOVE AIR CONDITIONING PANEL SUB-ASSEMBLY


    E234925
  1. Remove the 2 screws.



    E234926
  1. Disengage the 7 claws and remove the air conditioner panel sub-assembly.



14. REMOVE HEATER CONTROL HOUSING SUB-ASSEMBLY


    E232143
  1. Remove the 3 screws.

  1. Disengage the 4 claws and remove the heater control retainer RH from the heater control housing sub-assembly.



15. REMOVE HEATER CONTROL SWITCH BOARD

NOTICE:
When disassembling the air conditioning control assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.



    E228096
  1. Remove the 5 screws and heater control switch board.