Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL CLEARANCE WARNING ECU ASSEMBLY
  1. Engage the 2 claws to install the clearance warning ECU assembly.



2. INSTALL ECU INTEGRATION BOX RH
  1. Install the ECU integration box RH with the 2 nuts and bolt.

    Torque:
    Bolt:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }
    Nut:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect each connector.



3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)


    B281770
  1. Engage the 2 clips and 4 guides.

  1. Install the 3 screws <C>.

  1. Close the lower instrument panel door.

  1. Install the lower instrument panel sub-assembly with the bolt <B> and screw <C>.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
  1. Connect the connector.

  1. Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.



5. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for LHD .



6. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for LHD .



7. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
  1. Connect the connector.



    B287369
  1. Engage the 2 claws and 4 clips to install the upper instrument panel finish panel.



8. INSTALL FRONT PANEL GARNISH RH


    B384417
  1. Engage the 3 clips and 8 guides to install the front panel garnish RH.



9. INSTALL INSTRUMENT SIDE PANEL RH


    B281766
  1. Engage the 3 guides as shown in the illustration.



    B281764
  1. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.



10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B278981E01
  1. Align the alignment mark (White) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.
    Text in Illustration 
    *1
    Alignment Mark (White)

    NOTICE:
    After installation, check that the corners fit correctly.



11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



12. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .



13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


14. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
  1. Engage the claw to connect the luggage trim service hole cover.