Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .



5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B284920
  1. Disconnect the front door opening trim weatherstrip RH.



7. REMOVE INSTRUMENT SIDE PANEL RH


    B281763
  1. Using moulding remover, disengage the 4 claws as shown in the illustration.



    B281765
  1. Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.



8. REMOVE FRONT PANEL GARNISH RH


    B280332
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH as shown in the illustration.



9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


    B279888
  1. Disengage the 4 claws.

  1. Disengage the 2 guides.

  1. Disconnect the connector to remove the No. 2 instrument panel under cover sub-assembly.



10. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)


    B281767
  1. Remove the bolt <B> and screw <C>.

  1. Open the lower instrument panel door.



    B281768
  1. Remove the 3 screws <C>.



    B281769
  1. Disengage the 2 clips, 4 guides and remove the lower instrument panel sub-assembly as shown in the illustration.



11. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)


    B287390
  1. Disengage the 2 claws and 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the upper instrument panel finish panel.



12. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for LHD .



13. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for LHD .



14. REMOVE ECU INTEGRATION BOX RH


  1. for LHD:

    1. Disconnect each connector.



    2. E223728
    3. Remove the bolt, 2 nuts and ECU integration box RH.



  1. for RHD:

    1. Disconnect each connector.



    2. E227952
    3. Remove the bolt, 2 nuts and ECU integration box RH.



15. REMOVE CLEARANCE WARNING ECU ASSEMBLY


  1. for LHD:



      E223729
    1. Disengage the 2 claws and remove the clearance warning ECU assembly.



  1. for RHD:



      E229573
    1. Disengage the 2 claws and remove the clearance warning ECU assembly.