Home › Power Source / Network › POWER DISTRIBUTION › POWER MANAGEMENT CONTROL ECU

POWER MANAGEMENT CONTROL ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE FRONT PANEL GARNISH LH


    B280331
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



5. REMOVE FRONT DOOR SCUFF PLATE LH


    B395175E01
  1. Disengage the 2 claws (A) in the direction indicated by the arrows (1) shown in the illustration.

  1. Disengage the 2 claws (B) in the direction indicated by the arrows (2) shown in the illustration.

  1. Disengage the 6 claws (C) to remove the front door scuff plate LH.



6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B278978
  1. Remove the clip.

  1. Pull the cowl side trim sub-assembly LH in the direction indicated by the arrow shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.



7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B298720
  1. Disconnect the front door opening trim weatherstrip LH.



8. REMOVE INSTRUMENT SIDE PANEL LH


    B280320
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B280322
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for LHD)


    B279865
  1. Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.



10. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)


    B280327
  1. Remove the 2 bolts <B>.



    B281943
  1. Disengage the 5 clips and 3 guides to remove the instrument panel sub-assembly.



11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for the RH side .



12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

HINT:
Use the same procedure as for the RH side .



13. REMOVE POWER MANAGEMENT CONTROL ECU


    B293079
  1. Disconnect the 4 connectors.



    B293080
  1. Remove the 2 nuts and power management control ECU.