EGR VALVE > INSTALLATION |
| 1. INSTALL EGR VALVE ASSEMBLY |
Install 2 new gaskets to the intake manifold and No. 1 EGR pipe.
Type A:
Temporarily install the EGR valve assembly to the intake manifold with the 4 bolts.
Temporarily install the 2 nuts to the EGR valve assembly.
Tighten the 4 bolts.
Type B:
Temporarily install the EGR valve assembly to the intake manifold with the 3 bolts.
Temporarily install the 2 nuts to the EGR valve assembly.
Tighten the 3 bolts.
Using a 12 mm deep socket wrench, tighten the 2 nuts.
Using a 10 mm deep socket wrench, install the bolt to the EGR valve assembly.
Connect the 2 water by-pass hoses to the EGR valve assembly and slide the 2 clips to secure them.
Connect the EGR valve assembly connector.
| 2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
Install the air cleaner hose with the hose clamp.
![]() |
Connect the 2 fuel vapor feed hoses.
| *1 | Retainer |
| *a | Push |
Install the air cleaner cap sub-assembly with the 2 clamps.
Connect the connector.
Connect the ventilation hose to the cylinder head cover.
Connect the mass air flow meter connector and wire harness clamp to the air cleaner cap sub-assembly.
| 3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Fit the 3 retainers and install the No. 1 engine cover sub-assembly.
| 4. ADD COOLANT (for Engine) |
Tighten the radiator drain cock plug by hand.
Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Capacity |
| Engine coolant | 7.2 liters (7.6 US qts, 6.3 lmp. qts) |
Slowly pour coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level is low, add coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Put the engine in inspection mode (Click here).
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand to bleed air.
Stop the engine and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 5. INSPECT FOR COOLANT LEAK (for Engine) |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Put the engine in inspection mode (Click here).
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
| 6. PERFORM INITIALIZATION |
Perform the "Inspection After Repair" after replacing the EGR valve assembly (Click here).