EGR VALVE > REMOVAL |
| 1. DRAIN COOLANT (for Engine) |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.
| 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.
Disconnect the ventilation hose from the cylinder head cover.
Disconnect the connector.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
![]() |
Disconnect the 2 fuel vapor feed hoses.
| *1 | Retainer |
| *2 | Fuel Tube Connector |
| *3 | Pipe |
| *4 | O-ring |
| *a | Pull |
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
| 4. REMOVE EGR VALVE ASSEMBLY |
![]() |
Disconnect the EGR valve assembly connector.
![]() |
Slide the 2 clips and disconnect the 2 water by-pass hoses from the EGR valve assembly.
![]() |
Using a 10 mm deep socket wrench, remove the bolt from the EGR valve assembly.
Using a 12 mm deep socket wrench, remove the 2 nuts from the EGR valve assembly.
Type A:
![]() |
Remove the 4 bolts and EGR valve assembly from the intake manifold.
Type B:
![]() |
Remove the 3 bolts and EGR valve assembly from the intake manifold.
![]() |
Remove the 2 gaskets from the intake manifold and No. 1 EGR pipe.