Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › VACUUM SENSOR

VACUUM SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A259744
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A258676
  1. Disconnect the connector.



    A257328
  1. Disconnect the vacuum hose.

  1. Remove the bolt and manifold absolute pressure sensor.