Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IGNITION CONTROL RELAY (IGCT)


    A253297E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Ignition Control Relay

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Auxiliary battery voltage is not applied across terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Auxiliary battery voltage is applied across terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



2. INSPECT HYBRID WATER PUMP RELAY (INV W/PMP)


    E222294E05
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Hybrid Water Pump Relay

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Auxiliary battery voltage is not applied across terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Auxiliary battery voltage is applied across terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.