Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER MIRROR


    B280618E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.



    B280619E01
  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



    B280621
  1. Disengage the 2 guides as shown in the illustration.



    B280623
  1. Disconnect the 2 connectors and remove the outer mirror.



2. REMOVE OUTER MIRROR COVER


    B280624
  1. Remove the 3 screws.



    B280625
  1. Disengage the clamp.

  1. Disconnect the 2 connectors and remove the mirror actuator.



    B280627
  1. Disengage the 7 claws and remove the outer mirror cover.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E225012
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly.



4. REMOVE OUTER MIRROR RETRACTOR


    B283064
  1. Remove the vinyl tape.



    B283065E01
  1. Cut the wire harness at the position shown in the illustration.
    Text in Illustration 
    *a
    Cut

    NOTICE:
    Make sure to replace the wire harness with a new one.



    B283066
  1. Disengage the 5 pins and remove the gasket.

    NOTICE:
    Make sure to replace the gasket with a new one.



    B283067
  1. Using a screwdriver, disengage the 2 claws.



    B283068
  1. Disengage the 3 claws and remove the lower cover as shown in the illustration.

    NOTICE:
    Make sure to replace the lower cover with a new one.



    B283070
  1. Disengage the clamp.

  1. Using a T25 "TORX" socket wrench, remove the 3 screws and base.

    NOTICE:
    Make sure to replace the "TORX" screws with new ones.



    B283071
  1. Disengage the clamp.

  1. Remove the 3 screws.



    B283072
  1. Remove the frame sub-assembly and wire harness as shown in the illustration.

    NOTICE:
    Make sure to replace the frame sub-assembly wire harness with a new one.



    B283073
  1. Remove the support as shown in the illustration.

    NOTICE:
    Make sure to replace the support with a new one.