Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › COMBINATION SWITCH

COMBINATION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT EV DRIVE MODE SWITCH


    A259195E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I48-4 (S) - I48-1 (E)
    EV drive mode switch being pushed and held
    Below 1 Ω
    I48-4 (S) - I48-1 (E)
    EV drive mode switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (EV Drive Mode Switch)
    If the result is not as specified, replace the EV drive mode switch.



    A259195E03
  1. Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch.

    Standard Resistance:
    Measurement Condition
    Specified Condition
    Auxiliary battery positive (+) → I48-3 (ILL+) Auxiliary battery negative (-) →I48-2 (ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (EV Drive Mode Switch)
    If the result is not as specified, replace the EV Drive Mode Switch.